Rear Sway Stabilizer Bar Linkage Suspension Part For INFINITI Nissan

Fitting the Following vehicle:
2008-2012 Infiniti EX35
2013 Infiniti EX37
2011-2012 Infiniti G25
2003-2008 Infiniti G35
2008-2013 Infiniti G37
2006-2010 Infiniti M35
2006-2010 Infiniti M45
2015 Infiniti Q40
2014-2015 Infiniti Q60
2014-2017 Infiniti QX50
2003-2009 Nissan 350Z
2009-2018 Nissan 370Z

Package Includes:
1x Rear Sway Bar End Link - Driver Side -K7500441x Rear Sway Bar End Link - Passenger Side -K750047

Note

(2). Although some parts have grease fittings, other parts are factory sealed, but do not affect the fit and quality of the parts

10 Year Warranty

This item is backed by our 10-year warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only

Sway Bar Stabilizer Link Replacement Guideline:

While driving, the following signs may indicate a faulty sway bar stabilizer link:
(1).Rattling and thumping noises on rough roads
(3).Stronger inclination of the vehicle during cornering
If the sway bar stabilizer link is found to be defective, it should be replaced as described below
1.Raise vehicle and remove front wheels
Tip:Always check both stabilizer links and replace them in pairs if necessary
2.Spray fastening nuts of the stabilizer link with rust remover and let act for a few minutes

3.Loosen the lower fastening nut of the stabilizer link at the stabilizer and remove
Tip:If the ball stud also starts to turn, hold it with a suitable tool
4.Press stabilizer link out of torsion bar

5.Loosen the upper fastening nut of the stabilizer link at the suspension strut and remove it

6.Press stabilizer link at suspension strut out of bracket

7.Insert new stabilizer link at suspension strut

8.Tighten stabilizer link at suspension strut to the tightening torque specified by the vehicle manufacturer
Tip:Secure the ball stud against twisting with a suitable tool

9.Insert new stabilizer link at stabilizer
10.Tighten stabilizer link at stabilizer to the tightening torque specified by the vehicle manufacturer

11.Remount the front wheels. Lower the vehicle and tighten the wheel studs to the tightening torque specified by the vehicle manufacturer
Tip:Even if replacing the stabilizer link does not directly affect the chassis setting, we recommend checking the axle setting and adjusting if necessary after working on the suspension
12.Conclude with a test drive

Frequently Asked Questions

(1).Why should I get my tie rods inspected on a regular basis?

(2).Vibrations

(3).Shaking

(4).Wandering